Description of the gas spring 176384 – Stroke 150 mm – 200 N
The 176384 gas spring is a 316L stainless steel strut that gives controlled lift and reliable support to lids, lockers and hatches on board. It provides 200 N of force over a 150 mm stroke. It comes fitted with plastic ball sockets at both ends, so it is ready to install on standard ball studs.
This marine gas strut was produced as original equipment for Beneteau and is also fitted on Bali Catamarans. It is the right replacement when the factory strut has lost pressure and a lid will no longer stay open or drops back down. It is 376 mm long between ball-socket centres when extended, so it goes straight back onto the existing mounting points without any modification to the boat or catamaran.
The body and rod are made of 316L stainless steel, the reference grade for marine hardware. This grade holds up to salt spray, condensation and the humidity in lockers and cockpit stowage. The cylinder is 23 mm in diameter and the rod is 10 mm, which gives a sturdy, compact unit suited to the confined spaces found on sailing and motor boats.
Specifications
- Type: Gas spring with plastic ball sockets
- Reference: 176384
- Material: 316L stainless steel
- Force: 200 N
- Stroke: 150 mm
- Extended length (without end fittings): 340 mm
- Extended length (ball-socket centre to centre): 376 mm
- Cylinder diameter: Ø 23 mm
- Rod diameter: Ø 10 mm
- End fittings: Plastic ball sockets on both ends (18 mm)
- Original equipment: Beneteau
Installation / Maintenance
Installation:
- Press the plastic ball sockets onto the existing ball studs. No tools are normally needed.
- Fit the strut with the rod pointing downwards when the lid is closed. This keeps the internal seal lubricated and extends its service life.
- Check that the new spring matches the stroke and centre-to-centre length of the original part before you fit it.
Maintenance:
- Keep the rod clean. Wipe off salt deposits and grit with fresh water and a soft cloth.
- Never grease, scratch or paint the rod, because this damages the seal.
- Gas springs on a lid are usually fitted in pairs, so replace both at the same time to keep the load balanced.
Our review
✔️ Pros :
- 316L stainless steel, built for the marine environment.
- Original-equipment dimensions for a direct fit on Beneteau boats and Bali Catamarans.
- Plastic ball sockets come pre-fitted, so it is ready to install.
- Quiet, well-supported opening.
❌ Cons :
- The force is fixed at 200 N and cannot be adjusted.
- The plastic sockets are less robust than stainless steel ones for heavy loads.
- A gas spring cannot be repaired: once it loses pressure, it has to be replaced.
Conclusion
The 176384 is the right choice if you want to restore the original lift on a Beneteau or Bali catamaran locker or hatch with a stainless steel part built for life at sea.Before ordering, compare the reference printed on your old strut or measure it: the stroke should be 150 mm and the length between ball-socket centres 376 mm. If the lid is heavier or lighter than intended, a version with the same dimensions and a different force will be a better fit. If in doubt, our team can help you identify the right part.
Good to Know
- The reference is printed on the label on the cylinder, so check it before ordering.
- The same dimensions are available in other forces: 100 N (180164) and 400 N (181970).
- Do not open, drill or heat the strut, because it contains gas under high pressure.
- Supplied as a single unit. Order two if your lid uses a pair.

Electrical
Marine Batteries
Mechanical
Gas Springs
Seat suspensions
Table solutions
TV Lift



English spoken
On parle Français

Reviews
There are no reviews yet.