Description of the gas spring 124037 – Stroke 250 mm – 400 N
The 124037 gas spring is a 316L stainless steel strut designed to lift and hold heavy lids, hatches and lockers on board. It develops 400 N of force over a 250 mm stroke. Both ends have stainless steel ball sockets, so the strut clips straight onto standard Ø 10 mm ball studs.
This marine gas strut was produced as original equipment for Beneteau. It is 585 mm long between ball-socket centres when extended, so it fits back onto the existing mounting points without any modification. It is the right part to order when the factory strut has lost pressure and a hatch drops back down or will no longer stay open.
The body and rod are made of 316L stainless steel, the reference grade for nautical hardware exposed to salt spray. The ball sockets are made of 304 stainless steel. This all-metal construction is more robust than plastic end fittings, which makes it a good choice for heavier panels, high-use deck lockers and installations in exposed areas of the boat.
Specifications
- Type: Gas spring with stainless steel ball sockets
- Reference: 124037
- Material: 316L stainless steel (body and rod), 304 stainless steel (ball sockets)
- Force: 400 N
- Stroke: 250 mm
- Extended length (without end fittings): 549 mm
- Extended length (ball-socket centre to centre): 585 mm
- End fittings: Stainless steel ball sockets on both ends (18 mm), for Ø 10 mm ball studs
- Original equipment: Beneteau
Installation / Maintenance
Installation:
- Lift the retaining clip on each ball socket, press the socket onto the Ø 10 mm ball stud, then release the clip.
- Fit the strut with the rod pointing downwards when the hatch is closed. This keeps the internal seal lubricated.
- Before fitting, check that the stroke and centre-to-centre length match the original part.
Maintenance:
- Rinse off salt deposits with fresh water and keep the rod clean.
- Never grease, scratch or paint the rod, because this damages the seal.
- When the lid uses two struts, replace both at the same time to keep the load balanced.
Our review
✔️ Pros :
- All-stainless construction, suited to the marine environment.
- Stainless ball sockets are more durable than plastic ones.
- Original-equipment dimensions for a direct fit on Beneteau boats.
- 400 N of force for heavy hatches and lids.
❌ Cons :
- The force is fixed and cannot be adjusted.
- 400 N may be too strong for a light lid.
- A gas spring cannot be repaired: once it loses pressure, it has to be replaced.
Conclusion
The 124037 is a good choice for restoring the original lift on a heavy Beneteau hatch or locker with a fully stainless part. Before ordering, check the reference printed on your old strut, or measure it: the stroke should be 250 mm and the length between ball-socket centres 585 mm. If your original strut has plastic end fittings, the 081489 is the same strut with plastic ball sockets. If in doubt, our team can help you identify the right part.
Good to Know
- The reference is printed on the label on the cylinder, so check it before ordering.
- Also available with plastic ball sockets: reference 081489.
- Do not open, drill or heat the strut, because it contains gas under high pressure.
- Supplied as a single unit. Order two if your lid uses a pair.

Electrical
Marine Batteries
Mechanical
Gas Springs
Seat suspensions
Table solutions
TV Lift

English spoken
On parle Français

Reviews
There are no reviews yet.