Description of the gas spring 139848 – Stroke 250 mm – 500 N
The 139848 gas spring is a 316L stainless steel strut designed to lift and hold heavy lids, hatches and lockers on board. It develops 500 N of force over a 250 mm stroke. Both ends come fitted with plastic ball sockets that clip directly onto standard Ø 10 mm ball studs.
This marine gas strut was produced as original equipment for Beneteau. It is 585 mm long between ball-socket centres when extended, so it fits back onto the existing mounting points without any modification to the boat. It is the right part to order when the factory strut has lost pressure, a heavy hatch drops back down, or a lid will no longer stay open in a swell.
The body and rod are made of 316L stainless steel, the reference grade for nautical hardware exposed to salt spray and condensation. The ball sockets are moulded in glass-fibre reinforced nylon, which does not corrode and is rated well above the strut’s 500 N force. The result is a sturdy, long-lasting unit suited to the larger hatches and deck lockers found on sailing and motor yachts.
Specifications
- Type: Gas spring with plastic ball sockets
- Reference: 139848
- Material: 316L stainless steel (body and rod), glass-fibre reinforced nylon (ball sockets)
- Force: 500 N
- Stroke: 250 mm
- Extended length (without end fittings): 549 mm
- Extended length (ball-socket centre to centre): 585 mm
- End fittings: Plastic ball sockets on both ends (18 mm), for Ø 10 mm ball studs
- Original equipment: Beneteau
Installation / Maintenance
Installation:
- Support the hatch in the open position before removing the old strut.
- Press the ball sockets onto the Ø 10 mm ball studs until they clip into place.
- Fit the strut with the rod pointing downwards when the hatch is closed. This keeps the internal seal lubricated.
Maintenance:
- Rinse off salt deposits with fresh water and keep the rod clean.
- Never grease, scratch or paint the rod, because this damages the seal.
- When the lid uses two struts, replace both at the same time to keep the load balanced.
Our review
✔️ Pros :
- 316L stainless steel, built for the marine environment.
- 500 N of force for heavy hatches and lids.
- Original-equipment dimensions for a direct fit on Beneteau boats.
- Ball sockets come pre-fitted and clip on without tools.
❌ Cons :
- The force is fixed and cannot be adjusted.
- 500 N is too strong for a light lid, which may then be hard to close.
- A gas spring cannot be repaired: once it loses pressure, it has to be replaced.
Conclusion
The 139848 is the right replacement for a heavy Beneteau hatch or locker that needs a strong, reliable stainless strut. Before ordering, check the reference printed on your old strut, or measure it: the stroke should be 250 mm and the length between ball-socket centres 585 mm. If the lid is lighter, the same strut exists in 400 N (081489). If you want stainless steel end fittings, look at the 124037. If in doubt, our team can help you identify the right part.
Good to Know
- The reference is printed on the label on the cylinder, so check it before ordering.
- Same dimensions available in other forces: 200 N (081487) and 400 N (081489).
- A replacement ball socket is available on its own: reference 124059.
- Do not open, drill or heat the strut, because it contains gas under high pressure.
- Supplied as a single unit. Order two if your lid uses a pair.

Electrical
Marine Batteries
Mechanical
Gas Springs
Seat suspensions
Table solutions
TV Lift

English spoken
On parle Français

Reviews
There are no reviews yet.