Description of the stainless steel gas spring 100155
The 100155 stainless steel gas spring is an official Dufour Yachts part, made by Ressorts SPEC (AS Raymond / Barnes Group) and fitted as original equipment on Dufour sailing yachts. It is a compression strut: it pushes its rod out with a force of 200 N over a short 100 mm stroke, giving firm opening assistance and a steady hold for compact but relatively heavy components on board, such as small hatches, locker lids and cabinet doors.
The strut is made of 316L stainless steel, a low-carbon grade with excellent corrosion resistance in the marine environment. It does not rust, even when exposed to salt air, spray or the condensation in lockers and galleys. With an 8 mm rod and an 18 mm body, it offers a good balance between force and compactness, and fits discreetly into joinery. Its 249 mm length (without end fittings) matches the original Dufour installation.
The 100155 has an M6 x 1.0 thread at each end and is supplied without end fittings. In most cases you simply unscrew the fittings from the worn strut and screw them onto the new one. A label printed on the body shows the reference and force, which makes future replacements easy to identify. Choose this strut when your original part is marked 100155 or matches its length, stroke and force.
Specifications
- Type: Compression gas spring
- Reference: 100155
- Force: 200 N
- Stroke: 100 mm
- Length (extended, without end fittings): 249 mm
- Rod diameter: 8 mm
- Body diameter: 18 mm
- Thread: M6 x 1.0 at both ends
- End fittings: not included
- Material: 316L stainless steel
Boat compatibility
- Brand: DUFOUR – official Dufour Yachts part, reference 100155
Installation / Maintenance
Installation:
- Hold the lid open, unscrew the end fittings from the worn strut and screw them onto the 100155.
- Mount the strut with the rod pointing down where possible to keep the seal lubricated.
- Check that the lid opens fully and closes without binding or side load on the rod.
Maintenance:
- Rinse with fresh water from time to time and keep the rod clean. Never scratch or paint it, as this damages the seal.
- Never heat, open or drill the body, which is pressurised.
- A strut that no longer holds the lid open must be replaced: it cannot be refilled.
Our review
✔️ Pros :
- Official Dufour Yachts part: exact original fit.
- 316L stainless steel: no rust, even in exposed locations.
- Compact format with a firm 200 N force.
- Lets you reuse your existing end fittings.
❌ Cons :
- End fittings not included.
- Fixed 200 N force, not adjustable.
- Short 100 mm stroke, for small hatches and lids only.
Conclusion
If your Dufour has a strut printed 100155, or one that measures 249 mm with a 100 mm stroke and a 200 N force, this is the right replacement. Its 316L stainless construction makes it a long-lasting choice, even in damp or exposed locations. Keep your existing M6 end fittings or order new ones separately. If any value differs from your original strut, contact our team before ordering.
Good to Know
- Official Dufour Yachts part.
- Before ordering, compare three values: length (249 mm), stroke (100 mm) and force (200 N).
- Supplied without end fittings: M6 x 1.0 thread at both ends.
- Manufacturer: Ressorts SPEC. See all Ressorts SPEC products and our marine gas springs.

Electrical
Marine Batteries
Mechanical
Gas Springs
Seat suspensions
Table solutions
TV Lift

English spoken
On parle Français

Reviews
There are no reviews yet.