Description of the gas spring 147349 – Stroke 200 mm – 150 N
The 147349 gas spring is a black nitrided strut designed to lift and hold light lids, lockers and cabinet doors on board. It develops 150 N of force over a 200 mm stroke. Both ends come fitted with plastic ball sockets that clip directly onto standard Ø 10 mm ball studs.
This marine gas strut was produced as original equipment for Beneteau. It is 485 mm long between ball-socket centres when extended, so it fits back onto the existing mounting points without any modification to the boat. It is the right part to order when the factory strut has lost pressure and a lid no longer stays open or closes on its own.
The body is made of carbon steel with a black e-coat finish, and the rod is carbon steel with a black nitrided surface treatment. Nitriding hardens the rod surface and improves its resistance to wear and corrosion, while the black finish gives a discreet look inside saloons and cabins. This construction is intended for interior or sheltered installations on board. For deck lockers exposed to spray, a stainless steel strut is a better choice.
Specifications
- Type: Nitrided gas spring with plastic ball sockets
- Reference: 147349
- Material: Carbon steel body (black e-coat), carbon steel rod (black nitrided)
- Force: 150 N
- Stroke: 200 mm
- Extended length (without end fittings): 449 mm
- Extended length (ball-socket centre to centre): 485 mm
- End fittings: Plastic ball sockets on both ends (18 mm), for Ø 10 mm ball studs
- Finish: Black
- Original equipment: Beneteau
Installation / Maintenance
Installation:
- Support the lid in the open position before removing the old strut.
- Press the ball sockets onto the Ø 10 mm ball studs until they clip into place.
- Fit the strut with the rod pointing downwards when the lid is closed. This keeps the internal seal lubricated.
Maintenance:
- Keep the rod clean and dry, and wipe off any dust or moisture.
- Never grease, scratch or paint the rod, because this damages the seal.
- When the lid uses two struts, replace both at the same time to keep the load balanced.
Our review
✔️ Pros :
- Original-equipment dimensions for a direct fit on Beneteau boats.
- Discreet black finish for interior joinery.
- The nitrided rod resists wear.
- Ball sockets come pre-fitted and clip on without tools.
❌ Cons :
- Not stainless steel, so it is not recommended for areas exposed to spray.
- The force is fixed at 150 N and cannot be adjusted.
- A gas spring cannot be repaired: once it loses pressure, it has to be replaced.
Conclusion
The 147349 is the right replacement for a light interior locker or cabinet lid on a Beneteau boat that was originally fitted with a black strut. Before ordering, check the reference printed on your old strut, or measure it: the stroke should be 200 mm and the length between ball-socket centres 485 mm. For a heavier lid, the same nitrided strut exists in 250 N (081484) and 400 N (081486). For an exposed deck locker, choose a stainless steel version instead. If in doubt, our team can help you identify the right part.
Good to Know
- The reference is printed on the label on the cylinder, so check it before ordering.
- Same dimensions in black nitrided version: 250 N (081484) and 400 N (081486).
- Same dimensions in 316L stainless steel: 100 N (081481), 250 N (081483), 300 N (173056) and 400 N (081485).
- A replacement ball socket is available on its own: reference 124059.
- Supplied as a single unit. Order two if your lid uses a pair.

Electrical
Marine Batteries
Mechanical
Gas Springs
Seat suspensions
Table solutions
TV Lift

English spoken
On parle Français

Reviews
There are no reviews yet.